Savin 8700W manual Paper/Toner

Page 61

PAPER/TONER

Notes on Paper

SDo not set the following paper. Otherwise, a paper jam might occur.

∙ Bent, folded, or creased paper	∙ Torn paper
∙ Perforated paper	∙ Non-smooth paper
∙ Slippery paper	∙ Thin paper that has low stiffness

SDo not make a copy on paper with any kind of coating, such as thermosen- sitive paper, art paper, aluminum foil, and carbon paper. Otherwise, a fault might occur.

SIf you make a copy on edged paper, the copy might be creased or a part of the image might not be copied.

SWhen you use roll paper, the roll must be black.

SWhen film is delivered from the copier, it is softened due to the fusing heat. Place the film on a flat surface until the remaining heat is removed from the film.

SIf you make a copy on rough paper, the copy image might be blurred.

SKeep paper away from humidity. Once you unpack the container of paper, store the paper in a polyvinyl bag in the following locations:

∙Location free from direct sunlight ∙ Location with the humidity of 70

∙	Flat location	% or less

Toner

SStore toner cartridges levelly in the following locations:

∙Location free from direct sunlight ∙ Locations the toner could be subjected to temperature of over 35 °C, 95 °F

RWARNING: Do not incinerate toner or toner containers. Toner dust

might ignite when exposed to open flames.

Dispose of the used toner container according to local regulations.

❐Do not store toner where it will be exposed to heat.

❐Do not eat or swallow toner, and keep it out of reach of children.

54 MAINTAINING YOUR COPIER

Image 61

Contents Operating Instructions Ifor the main switch Safety During Operation Safety InformationIntroduction Examples Of IndicationsSafety Information Safety Information Table of Contents What to do if Something Goes Wrong Main Unit Copier ExteriorOperation Panel Indicator PanelCopying Recommended Originals BasicRecommended Paper Copying Switching the Fusing Temperature Setting the Number of Copies Repeated Copying Press the Lighter and Darker keys to adjust copy density Adjusting Copy DensitySwitching the Copy Exit Copying Setting a Leading/Trailing Edge Margin Copying Synchro Cutting Copying Onto Roll PaperPreset Cutting Copying Variable Cutting Copying Partial Copying Partial Copying Sample Copying Paper TYPE/ROLL Width Entry Function Press the Fusing Temperature key to select the paper type Programming a Collection of Copy Settings Using the Program FunctionUsing the Program Function Recalling Programmed Settings Copying with Manual Feed Copying with Manual Feed What to do if Something Goes Wrong When the Wait Indicator is LIT Blurred Copies Dirty CopiesSpotty or Partially Blank Copies Creased Copies Waved CopiesWhen a or x is LIT When a and Are Lit When x and Are Lit What to do if Something Goes Wrong When Is Lit When C is LIT When C is LIT What to do if Something Goes Wrong Cutting the Paper Automatically Cutting the Paper Manually When D is LIT or Blinking When D is LIT or Blinking What to do if Something Goes Wrong Page Maintaining Your Copier Functions That can be Reset Copy MAGNIFICATION/CUT Length Adjustment Copy MAGNIFICATION/CUT Length Adjustment DO’S and DON’TS DO’S and DON’TS Daily Maintenance Toner PAPER/TONERInstallation Conditions Where to PUT Your CopierDisposal Space Required for Installing the CopierPower Connection Page Specifications Spirio 700W SpecificationsISO 3rd Roll FeederOther Options