Installation (The installation work must be performed by your dealer without fail.)
$ Installing the pan/tilt head
Be absolutely sure to follow the instructions below when installing the pan/tilt head. Failure to do so may cause the pan/tilt head to slip out of position or fall.
OFor wall
Do not install the pan/tilt head on any of its sides.
The wall should be capable of supporting a weight of at least four times the pan/tilt head with camera etc. weight 59.5 lb (27 kg).
OMake sure that the installation of the pan/tilt head has been completed before mounting the camera onto it.
OTo mount the pan/tilt head, use the four mounting holes and secure it firmly in place. OHave M6 hexagonal bolts ready as these must be used for mounting the pan/tilt head. OThe hexagonal bolts must be long enough to meet the requirement of “mounting material
thickness plus 25 mm or longer”.
OUse flat washers, spring washers and hexagonal nuts with the hexagonal bolts, as shown in the figure.
OUse a wrench that fits the size of hexagonal bolt heads to tighten the hexagonal bolts. OFor suspended installation, pass a wire through the safety wire mounting hole, and
fasten it securely to the ceiling or other structurally sound object.
OHave a wire ready which is strong enough to bear the weight of the entire pan/tilt head system (pan/tilt head, camera, lens and cable).
OInstall the pan/tilt head so as to ensure that none of the components mounted on the pan/tilt head or cables will come into contact with any objects in the vicinity when the pan/tilt head rotates.
<Note>
When installing the pan/tilt head, refrain from forcibly turning the head or tilting arm by hand. Doing so may cause the unit to malfunction.
Safety wire
- 13 -