Panasonic AW-PH360N manual Equivalent to

Color monitor

Multi hybrid control panel: AW-RP505

Genlock signals must be supplied if a multiple number of cameras and pan/tilt heads are to be used.

Connections

5When the camera and pan/tilt head are to be controlled by the AW-RP505 control panel for transmitting component signals

Camera cable (supplied)

Coaxial cable

	10BASE-T (equivalent
	to UTP category 5)
	straight cable, max.
	33 ft. (10 m)
	10BASE-T
	(equivalent to
	UTP category
	5) straight
DC cable	cable, max.
	1640 ft. (500 m)
(UL Type SPT-2 2!16 AWG
or UL Type NISPT-2 2!16
AWG, to be locally
purchased)

AC adapter: AW-PS300A

Coaxial cable (BELDEN 8281), max. 1640 ft. (500 m)

Coaxial cable

(BELDEN 8281), max. 33 ft. (10 m)

Multiport hub: AW-HB505

•Use the supplied camera cable to connect the unit with the convertible camera.

•Set controller selection switch SW1 to the right side (RP501), and select the transmission signal selection setting that supports the analog/IEEE1394 card.

•Use a 10BASE-T straight cable (UTP category 5) to connect the unit’s CONTROL IN IP/RP connector with the multiport hub’s PAN/TILT CONTROL OUT connector.

•Use a coaxial cable (BELDEN 8281) to connect the unit’s CAMERA CONTROL IN connector with the multiport hub’s CAMERA CONTROL OUT connector.

•Use a 10BASE-T straight cable (UTP category 5) to connect the multiport hub’s PAN/TILT CONTROL IN connector with the controller’s PAN/TILT CONTROL OUT connector.

•Use a coaxial cable (BELDEN 8281) to connect the multiport hub’s CAMERA CONTROL IN connector with the controller’s CAMERA CONTROL OUT connector.

•Use coaxial cables to connect the unit’s Y OUT connector, Pr/SDI OUT connector and Pb OUT connector with the component input connectors on the color monitor.

•Check that the pan/tilt head and camera can be controlled by the controller.

•Transmitting component signals over a long distance requires a separate cable compensation unit.

- 31 -