Panasonic AW-PH360N manual AW-PS300A

Connections

2When the camera and pan/tilt head are to be controlled by the AW-RP501 control panel for transmitting component signals

Camera cable (supplied)

Color monitor

Coaxial cable

Coaxial cable (BELDEN 8281),

max. 1640 ft. (500 m)

DC cable

(UL Type SPT-2 2!16 AWG or UL Type NISPT-2 2!16 AWG, to be locally purchased)

	10BASE-T
	(equivalent to UTP
AC adapter:	category 5) straight
AW-PS300A	cable, max. 1640 ft.
	(500 m)

Hybrid control panel: AW-RP501

•Use the supplied camera cable to connect the unit with the convertible camera.

•Set controller selection switch SW1 to the right side (RP501), and select the transmission signal selection setting that supports the analog/IEEE1394 card.

•Use a 10BASE-T straight cable (UTP category 5) to connect the unit’s CONTROL IN IP/RP connector with the controller’s PAN TILT CONTROL OUT connector.

•Use a coaxial cable (BELDEN 8281) to connect the unit’s CAMERA CONTROL IN connector with the controller’s CAMERA CONTROL OUT connector.

•Use coaxial cables to connect the unit’s Y OUT connector, Pr/SDI OUT connector and Pb OUT connector with the component input connectors on the color monitor.

•Check that the pan/tilt head and camera can be controlled by the controller.

•Transmitting component signals over a long distance requires a separate cable compensation unit.

- 28 -