Panasonic AW-PH360N manual Connections

Connections

<When the pan/tilt head is to be controlled by the AW-RP400 pan/tilt head control panel for transmitting SDI signals (and the WV-CB700A remote control box is used to control the camera)

Coaxial cable

Camera cable

(supplied)Cable supplied with WV-CB700A

Remote control box: WV-CB700A

Pan/tilt control panel: AW-RP400

10BASE-T (equivalent to UTP category 5) straight cable, max. 1640 ft. (500 m)

DC cable

(UL Type SPT-2 2!16 AWG or UL Type NISPT-2 2!16 AWG, to be locally purchased)

AC adapter: AW-PS300A

Coaxial cable (BELDEN 8281), max. 666 ft. (200 m)

Color monitor

•Use the supplied camera cable to connect the unit with the convertible camera containing the plugged-in SDI card (such as the AW-PB504N).

•Use a coaxial cable to connect the SDI card’s SDI OUT connector with the unit’s SDI IN connector. Adjust the cable to a length at which the pan/tilt head will move smoothly.

•Set controller selection switch SW1 to the right side (RP501), and select the transmission signal selection setting that supports the SDI card.

•Use a 10BASE-T straight cable (UTP category 5) to connect the unit’s CONTROL IN IP/RP connector with the controller’s CONTROL OUT TO PAN/TILT HEAD connector.

•Use a coaxial cable to connect the unit’s Pr/SDI OUT connector with the color monitor’s SDI input connector.

•Use the cable supplied with the remote control box to connect the controller’s CAMERA CONTROL IN FROM RCB connector with the remote control box’s RCB connector.

•Check that the pan/tilt head and camera can be controlled by the controller.

- 38 -