Panasonic AW-PH360N manual Coaxial cable Camera cable supplied

Connections

8When the camera and pan/tilt head are to be controlled by the AW-RP605A multi-function controller for transmitting SDI signals

Coaxial cable

Camera cable (supplied)

Genlock signals must be supplied if a multiple number of cameras and pan/tilt heads are to be used.

Coaxial cable

(BELDEN 8281), max.Color monitor 666 ft. (200 m)

Coaxial cable (BELDEN 8281), max. 3333 ft. (1000 m)

DC cable

(UL Type SPT-2 2!16 AWG or UL Type NISPT-2 2!16 AWG, to be locally purchased)

AC adapter: AW-PS300A

10BASE-T (equivalent to UTP category 5) straight cable, max. 3333 ft. (1000 m)

Multi-function controller: AW-RP605A

•Use the supplied camera cable to connect the unit with the convertible camera containing the plugged-in SDI card (such as the AW-PB504N).

•Use a coaxial cable to connect the SDI card’s SDI OUT connector with the unit’s SDI IN connector. Adjust the cable to a length at which the pan/tilt head will move smoothly.

•Set controller selection switch SW1 to the left side (RP605), and select the transmission signal selection setting that supports the SDI card.

•Use a 10BASE-T straight cable (UTP category 5) to connect the unit’s CONTROL IN IP/RP connector with the controller’s CONTROL OUT TO PAN/TILT HEAD connector.

•Use a coaxial cable to connect the unit’s Pr/SDI OUT connector with the color monitor’s SDI input connector.

•Check that the pan/tilt head and camera can be controlled by the controller.

- 34 -