Installation (The installation work must be performed by your dealer without fail.)
$ Mounting the camera
The pan/tilt head’s camera mounting section has a mechanism for maintaining the camera’s balance that moves the camera mounting plate using a guide roller as a fulcrum. Use the described recommended lenses corresponding to the camera to be used. (Before mounting a lens other than recommended lenses, consult with your dealer.)
1.Change the position of guide pin A and/or the camera mounting screws in accordance with the following installation of the pan/tilt head before mounting the camera.
2.Adjust the balance by loosening the guide screws and moving the camera mounting plate.
3.Upon confirming the position where the balance is maintained, firmly tighten the guide screws. If the balance cannot be maintained, change the position of guide pin B or the positions of the guide screws, and adjust the balance again.
<Note>
OThe guide roller is fixed in place. Do not remove the guide roller screw.
Camera mounting plate
Camera mounting screws
Guide pin A
Guide roller
Guide screw | Guide screw |
| Guide pin B |
<Suspended installation>
Guide pin A
Change the position of the camera mounting screws and the guide pin A to change the installation.
Camera mounting plate
Camera mounting screws
Guide roller
Guide screw | Guide screw |
| Guide pin B |
- 14 -