Panasonic AW-PH360N manual AC adapter AW-PS300A

Connections

3When the camera and pan/tilt head are to be controlled by the AW-RP501 control panel for transmitting SDI signals

Coaxial cable

Camera cable (supplied)

Coaxial cable

(BELDEN 8281),Color monitor max. 666 ft. (200 m)

Coaxial cable (BELDEN 8281),

max. 1640 ft. (500 m)

AC adapter: AW-PS300A

DC cable

(UL Type SPT-2 2!16 AWG or UL Type NISPT-2 2!16 AWG, to be locally purchased)

10BASE-T (equivalent to	Hybrid control panel:
UTP category 5) straight	AW-RP501
cable, max. 1640 ft. (500 m)

•Use the supplied camera cable to connect the unit with the convertible camera containing the plugged-in SDI card (such as the AW-PB504N).

•Use a coaxial cable to connect the SDI card’s SDI OUT connector with the unit’s SDI IN connector. Adjust the cable to a length at which the pan/tilt head will move smoothly.

•Set controller selection switch SW1 to the right side (RP501), and select the transmission signal selection setting that supports the SDI card.

•Use a 10BASE-T straight cable (UTP category 5) to connect the unit’s CONTROL IN IP/RP connector with the controller’s PAN TILT CONTROL OUT connector.

•Use a coaxial cable (BELDEN 8281) to connect the unit’s CAMERA CONTROL IN connector with the controller’s CAMERA CONTROL OUT connector.

•Use a coaxial cable to connect the unit’s Pr/SDI OUT connector with the color monitor’s SDI input connector.

•Check that the pan/tilt head and camera can be controlled by the controller.

- 29 -