Panasonic AW-PH360N manual Tilting arm

Page 8

Parts and their functions

1Tilting arm

This tilts in the vertical direction.

2Tilting arm fixing screws

M4!12 mm (4 screws supplied)

3Camera mounting plate

This is used to mount the convertible camera.

4Guide screws

These are used to maintain the camera’s balance and anchor the camera mounting plate.

5Guide pin

This determines the mounting direction of the camera.

6Guide roller

This serves as the fulcrum for maintaining the camera’s balance.

7Camera mounting screws (U1/4˝-20 UNC)

These are used to mount the camera and anchor it securely.

8Head

This rotates in the horizontal direction.

9Tally lamps (!2)

These light (red) in response to the selection signals.

:Head connector panel

This is used for connection with the camera and lens.

;Base

<Pan/tilt head mounting holes

These four holes are used for mounting the pan/tilt head.

=Safety wire mounting hole

This is used when attaching a wire to prevent the pan/tilt head from dropping.

>Base connector rear panel

This is used for connection with a controller, multi-port hub or AC adapter for the pan/tilt head.

?Base connector front panel

This is used for connection with a camera control or a personal computer.

- 8 -

Image 8
Contents AW-PH360N Indicates safety information FCC Note Introduction ContentsAccessories Installation precautions Precautions for use Parts and their functions Tilting arm OAttaching the tilting arm Suspended installation Stand-alone installation$ Assembling the pan/tilt head For suspended installation For stand-alone installationFor a soft landing For a precise landing$ Transmission signal selection setting OAnalog/IEEE1394 card settings Oweb card settingsOsdi settings Connector printed circuit boardWhen using the AW-RP400 controller $ Setting the cable compensation circuit of video signalsWhen using the AW-RP605A controller $ Installing the pan/tilt head Suspended installation $ Mounting the cameraMounting example when the camera side is heavy Mounting example when the lens side is heavyWith the AW-E655/AW-E750/AW-E860 OAttaching the chainWith the AW-E350/AW-E650 With the AW-E350/AW-E650 With the AW-E655/AW-E750/AW-E860 OAdjusting slack in the chainOMounting a camera Connections Monitor Connections Compensation unit $ Connecting the connector panel RS-232C control Zoom lens RS-232C cable AW-CA28T9$ Head connector panel As viewed from cable endConnector Pb OUT connector $ Connecting the AC adapter for use with the pan/tilt head DC 12V in terminal board$ Connection examples 10BASE-TAW-PS300A AC adapter AW-PS300A Equivalent to UTP Category 5 straight Cable, max ft 10 m Equivalent to Belden AW-RP605A Coaxial cable Camera cable supplied Panel is used to control the camera Coaxial cable Belden 8281, max ft m Color monitor AW-RC400 Connections Personal computer Belden 8281, max AW-CA50F29 AW-CA50E29 Limiters $ Setting/releasing the limiters OFor the controller AW-RP301/AW-RP305/AW-RP501/AW-RP505OFor the controller AW-RP605A OFor the controller AW-RP400 Replacement of consumable parts $ Replacing the battery$ Replacing the motor $ Replacing the gearSpecifications $ Functions/performance Page Page Panasonic Broadcast & Television Systems Company