Panasonic AW-PH360N manual $ Connection examples, 10BASE-T

Connections

$ Connection examples

1When the camera and pan/tilt head are to be controlled by the AW-RP501 control panel for transmitting composite signals

Camera cable (supplied)

Coaxial cable	Color monitor
(BELDEN 8281), max.
1640 ft. (500 m)

Coaxial cable

DC cable

(UL Type SPT-2 2!16 AWG or UL Type NISPT-2 2!16 AWG, to be locally purchased)

	10BASE-T
AC adapter:	(equivalent to UTP
	category 5) straight	Hybrid control panel:
AW-PS300A	cable, max. 1640 ft.
		AW-RP501
	(500 m)

•Use the supplied camera cable to connect the unit with the convertible camera.

•Set controller selection switch SW1 to the right side (RP501), and select the transmission signal selection setting that supports the analog/IEEE1394 card.

•Use a 10BASE-T straight cable (UTP category 5) to connect the unit’s CONTROL IN IP/RP connector with the controller’s PAN TILT CONTROL OUT connector.

•Use a coaxial cable (BELDEN 8281) to connect the unit’s CAMERA CONTROL IN connector with the controller’s CAMERA CONTROL OUT connector.

•Use a coaxial cable (BELDEN 8281) to connect the unit’s VIDEO OUT connector with the controller’s VIDEO IN connector.

•Use a coaxial cable to connect the controller’s VIDEO OUT connector with the color monitor’s VIDEO input connector.

•Check that the pan/tilt head and camera can be controlled by the controller.

- 27 -