Panasonic WV-NP1000 manual Monitoring Images on a PC, Monitor images from a single camera, Step

Monitoring Images on a PC

The following are descriptions of how to monitor images from the camera on a PC.

Monitor images from a single camera

Step 1

Start up the web browser.

Step 2

Enter the IP address designated using the Panasonic IP setup software in the address box of the browser. (Example: http://192.168.0.10)

Step 3

Press the [Enter] key on the keyboard.

→Live images will be displayed.

Important:

•When the HTTP port number is changed from "80", enter the IP address of the camera after "http://", for example "http://192.168.0.11".

•Configure the web browser to not use the proxy server. Refer to the network administrator when using the proxy server.

Notes:

•When "ON" is selected for "User Authentication", the authentication window will be displayed before dis- playing live images for the user name and password entries. The default user name and password are as follows.

User Name: admin

Password: 12345

To enhance the security, change the password for the user "admin". It is recommended to change this password periodically.

•When "Unicast" is selected for "Transmission type" (☞ page 24), up to 8 users can access the camera concurrently. When 8 users have been concurrently accessing already, the access limit message will be displayed for users who accessed subsequently.

•When "ON" is selected for "MPEG-4 transmission" (☞ page 24), MPEG-4 image will be displayed. When "OFF" is select, JPEG image will be dis- played. It is possible to display JPEG image even when "ON" is selected for "MPEG-4 transmission". In this case, the refresh interval will be limited. The refresh interval may be longer depending on a network environment, PC spec, photographic sub- ject, access traffic, etc.

Refer to the following page for further information about the "Live" page.

4