Compensate backlight
Set an area where backlight is to be compensated.
Step 1
Select "ALC" for "ALC/ELC" on the "CAMERA SETUP" page.
→The "ALC CONT" page will be displayed.
**ALC CONT**
BACK LIGHT COMP
BLCOFF
MASK SET
LEVEL ......128
-+
RET TOP END
Step 2
Move the cursor onto "BLC" and select "ON" or "OFF". ON: Backlight will be compensated automatically. (→ To
step 6)
OFF: Manually set an area where backlight is to be compensated. (→ To step 3)
Default: OFF
Step 3
Move the cursor onto "MASK SET" and press the [SET] button.
→The mask setup window will be displayed.
Step 4
Mask a bright area on the screen. Press the [SET] but- ton after selecting the desired area (selected area blinks) using the [Left], [Right], [Up] and [Down] buttons. When the selected area is masked, horizontal stripes and white fill will be displayed in the selected area alter- nately. When moving to the other area, the area will be displayed in white.
To mask the other areas, do the same procedures above.
<To cancel the mask setting>
Select the desired masked area and press the [SET] button.
To cancel the mask setting for all areas, press the [Left] and [Right] buttons for 2 seconds simultane- ously.
Step 5
After completing the mask settings, press the [SET] but- ton for around 2 seconds.
→The "ALC CONT" page will be displayed.
Step 6
Move the cursor onto "LEVEL" and adjust the level using the [Left] and [Right] buttons.
Note:
To reset to the default settings, press the [Left] and [Right] buttons simultaneously for 2 seconds or more.
57