Panasonic WV-NP1000, WV-NP1004 manual Configure the settings on the Special Setup

Configure the settings on the "SPECIAL SETUP" page

[SPECIAL SETUP]

Configure the settings relating to image quality can be configured on the "SPECIAL SETUP" page. The settings can be configured on the "SPECIAL SETUP" page.

Refer to the operating instructions (book) for descriptions of how to display the "SPECIAL SETUP" page.

SPECIAL SETUP page

**SPECIAL	SETUP**
CHROMA GAIN	......160
AP GAIN	......193
PEDESTAL	...	...113
	-	+
PIX OFF
CAMERA RESET	PUSH SW

RET TOP END

[CHROMA GAIN]

Adjust the chroma level (colour density).

Colour density will be incremented when the cursor is moved to the "+" direction, and will be decremented when the cursor is moved to the "–" direction.

Adjust the chroma gain while monitoring a vector colour scope or a colour video monitor.

[AP GAIN]

Adjust the aperture level.

Images will be sharper when the cursor is moved to the "+" direction, and will be softer when the cursor is moved to the "–" direction. Adjust the aperture level while monitoring a colour video monitor.

[PIX OFF]

Correct image defects (blemishes) such as scratches. Up to 16 points can be corrected.

Refer to page 62 for descriptions of how to correct defects.

[CAMERA RESET]

Reset the settings edited on the [Camera] tab to the default settings.

Press simultaneously the [Left] button, [SET] button and [Right] button for around 2 seconds after moving the cursor onto "PUSH SW" of "CAMERA RESET". The set- tings will be reset to the default settings.

Note:

Moire fringes (vertical interference pattern) may appear when shooting figures such in a carpet or drapes. In this case, move the cursor to the "–" direction to alleviate this problem.

[PEDESTAL]

Adjust the brightness of images.

Images will be brighter when the cursor is moved to the "+" direction, and will be darker when the cursor is moved to the "–" direction. Adjust the pedestal while monitoring an oscilloscope or a colour video monitor.

54