Configure the settings relating to the host authentication [Host]
Click the [Host] tab on the "Authentication setup" page. (☞ page 35)
The settings to restrict PCs (IP address) to access the camera can be configured on this page.
[Host authentication]
Select ON or OFF to determine whether or not to authenticate the host.
Default: OFF
Note:
By clicking [i] of "Host check", the registered host can be selected and the selected host’s IP address can be checked.
The registered IP address will be displayed with the access level. (Example: 192.168.0.21 [1])
To delete the registered host, click the [DEL] button after selecting the IP address to be deleted.
Important:
Before configuring the host authentication, it is nec- essary to register IP addresses of the PCs to be allowed to access the camera and determine their access levels. If "ON" is selected for "Host authenti- cation" before registering the hosts (IP addresses), it will be impossible to access the camera.
[IP Address]
Enter the IP address of the PC to be allowed to access the camera.
Notes:
•When "IP address/subnet mask" is entered, it is pos- sible to restrict PCs in each subnet.
•When the IP address already in use is entered and the [REG] button is clicked, the respective host infor- mation will be overwritten.
[Access level]
Select the access level of the host from the following.
1.Administrator/2. Camera control/3. Live only Refer to page 35 for further information about the access level.
Default: 3. Live only
36