Zebra Technologies Z6M manual Peel Spindle Assembly Printhead Rewind Media

16.Close the printhead assembly.

17.Close the value peel assembly using the value peel lever.

18.If the printer is paused (the PAUSE light is on), press the PAUSE key to enable printing.

Peeling starts automatically. Press the FEED key to test.

Transmissive	Media Supply Guide
Sensor

Value

Peel Printhead

Lever Assembly

Label			Dancer	Media Supply
				Hanger
Value				Take-up
Peel
				Spindle
Assembly
Printhead				Rewind Media
Open Lever				Guide
Ribbon	Media	Media	Thumbscrew
Sensor	Alignment
		Guide
	Spindle

Figure 18

Liner Removal

1.Cut the liner material between the media alignment spindle and the take-up spindle.

2.Rotate the take-up spindle counterclockwise until the rewind media guide is in the “12 o’clock” position.

3.Loosen the thumbscrew and slide out the rewind media guide to the end of the take-up spindle.

4.Slide the core with the liner material from the take-up spindle.

Zebra Z4M/Z6M Printers User’s Guide 29