:DUQLQJ³&877(5-$0
Problem | Solution |
| Turn off the printer power and unplug the printer. Inspect |
Cutter blade is in the media path. | the cutter module for debris and clean as needed following |
| the cleaning instructions on page 64. |
|
|
2872)0(025<
Problem | Solution | |
| Insufficient DRAM for the label length, downloaded fonts/ | |
| graphics, and images. | |
*There is not enough memory to perform the |
| |
Ensure that the device, such as FLASH memory or | ||
function shown on the second line of the error | PCMCIA card, is installed and not write protected or full. | |
message. |
| |
Ensure that the data is not directed to a device that is not | ||
| ||
| installed or available. | |
|
|
3ULQW4XDOLW\3UREOHPV
*HQHUDOSULQWTXDOLW\LVVXHV
Problem | Solution |
You are using an incorrect media and ribbon | Consult your authorized Zebra reseller/distributor for |
combination for your application. | information and advice. |
|
|
The printer is set at an excessive print speed | For optimal print quality, set the print speed to a lower |
to achieve optimal quality. | setting via ZPL II, the driver, or the software. |
|
|
The printer is set at an excessive darkness | For optimal print quality, set the darkness level to a lower |
level to achieve optimal quality. | setting via the front panel, the driver, or the software. |
|
|
The printhead is dirty. | Clean the printhead according to the instructions on |
| page 56. |
|
|
There is light printing (or no printing) on the | The pressure adjustment dials need to be adjusted. Follow |
left or right side of the label or the printed | the printhead pressure adjustment instructions on page 65. |
image is not sharp. |
|
|
|
Zebra Z4M/Z6M Printers User’s Guide | 71 |