/LQHU7DNHXS0RGH
(Liner
NOTE: This option is available on the Z4M printer only.
Refer to Figure 17.
1.Press the printhead open lever. The printhead assembly springs up.
2.Flip down the media supply guide.
3.Slide out the media guide as far from the printer frame as possible.
4.Place the roll of media on the media supply hanger and orient the media properly.
5.Flip up the media supply guide.
6.Slide in the media supply guide so that it just touches, but does not restrict, the edge of the roll.
7.Feed the media under the dancer, through the slot in the transmissive sensor, and under the ribbon sensor.
8.Pull approximately 18" (500 mm) of media through the front of the printer.
9.Remove the labels from the exposed media so that only the liner remains.
10.Ensure that the media is against the back of the transmissive sensor. Slide in the media guide so that it just touches, but does not restrict, the edge of the media.
11.Pull down the value peel lever to open the value peel assembly.
12.Feed the media over the
13.Close the printhead assembly.
14.Close the value peel assembly using the value peel lever.
15.Slide the liner into the slot (see inset) in the
spindle of the liner
16.Turn the spindle assembly counterclockwise a few times so that the liner is snug.
Slot
26 | Zebra Z4M/Z6M Printers User’s Guide |