Zebra Technologies Z6M manual Initialize Memory Card, Initialize Card, Initialize Flash Memory

Display Shows Action/Explanation

Initialize Memory Card

CAUTION: Perform this operation only when it is necessary to erase all previously stored information from the optional memory card. Press the SETUP/EXIT key to bypass this function.

1.Press the￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿INCREMENT￿￿(+)￿￿key￿￿￿to￿￿￿￿￿￿￿￿￿￿￿￿select “YES￿￿.” ￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

2.The display asks “INITIALIZE CARD?”. Press the INCREMENT (+)

	key to select “YES.”
3.	The front panel LCD asks “ARE YOU SURE?”.
INITIALIZE CARD 4.	Press the INCREMENT (+) key “YES”￿￿to begin initialization.

Press the DECREMENT (–) key “NO” to cancel the request and return to the “INITIALIZE CARD” prompt.

5.Press the SETUP/EXIT key followed by the SELECT key. If initialization is still in process, the front panel display flashes back and forth between

the two phrases “CHECKING B: MEMORY” and “PRINTER IDLE.” When initialization is complete, the printer automatically exits the configuration mode and the front panel displays “PRINTER READY.”

NOTE: Depending on the amount of memory in the memory card, initialization may take up to five minutes to complete.

Initialize Flash Memory

CAUTION: Perform this operation only when it is necessary to erase all previously stored information from the FLASH memory. Press the SETUP/EXIT key to bypass this function.

1. Press the￿￿￿￿￿￿￿￿￿￿￿INCREMENT￿￿￿￿￿￿￿￿￿(+)￿key￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿to select￿￿“YES.”￿￿￿ ￿

2.The display asks “INITIALIZE FLASH?”. Press the INCREMENT (+) key to select “YES.”

INIT FLASH MEM 3. The front panel LCD asks “ARE YOU SURE?”.

4.Press the INCREMENT (+) key “YES”￿￿to begin initialization.

Press the DECREMENT (–) key “NO” to cancel the request and return to the “INITIALIZE FLASH” prompt.

5.Press the SETUP/EXIT key followed by the SELECT key. If initialization is still in process, the front panel display flashes back and forth between the two phrases “CHECKING E: MEMORY” and “PRINTER IDLE.” When initialization is complete, the printer automatically exits the configuration mode and the front panel displays “PRINTER READY.”

NOTE: Depending on the amount of free FLASH memory, initialization may take up to one minute to complete.

44 Zebra Z4M/Z6M Printers User’s Guide