Zebra Technologies Z6M manual RQILJXULQJWKH3ULQWHU

&RQILJXULQJ￿WKH￿3ULQWHU

The configuration procedure in Table 1 contains the information you need to get your printer up and running, but it is not comprehensive. Refer to page 37 for more information.

1.Press the SETUP/EXIT key at the “PRINTER READY” display to enter the configuration mode.

NOTE: You need to press the INCREMENT (+) key more than once to advance to some of the displays.

2.Press the INCREMENT (+) or DECREMENT (–) key to scroll to the setting you wish to change.

3.Press the SELECT key to toggle the functionality of the INCREMENT (+) and DECREMENT (–) keys.

4.Press the INCREMENT (+) or DECREMENT (–) keys to increase or decrease the value; answer “yes” or “no”; print a label; or select the digit you wish to change.

5.Press the SELECT key again to use the INCREMENT (+) and DECREMENT (–) keys to scroll to the desired menu item.

	Table 1
Parameter	Selections/Explanation
PRINTER READY	You are ready to configure the printer
DARKNESS	0 to 30 (default setting is “10”)
PRINT MODE	Tear-off, peel-off, liner take-up, cutter, rewind (default setting is tear-off)
MEDIA TYPE	Non-continuous, continuous (default setting is “non-continuous”)
SENSOR TYPE	Web, mark (default setting is “web”)
PRINT METHOD	Thermal transfer, direct thermal (default setting is “thermal transfer”)

6.After you have configured the print method, press the SETUP/EXIT key to save the changes and exit the configuration mode.

14 Zebra Z4M/Z6M Printers User’s Guide