American Power Conversion S15BLK Inserting and Connecting the Battery, Front Bezel Removal

Page 23

Inserting and Connecting the Battery

In accordance with APC’s interpretation of Department of Transportation regulations, APC ships this device with the internal battery pack disconnected. The front bezel of the unit is also not attached to the unit when it is shipped.

This procedure is for connecting the battery when the front bezel has been prematurely installed onto the chassis. Perform the following steps to connect the internal battery pack:

1.Grasp the front panel at the sides, as shown in Figure 4, and pull the front bezel from the unit.

Figure 4. Front Bezel Removal

2.Remove the battery retaining bar, and continue to Step 3.

2-3

Image 23

Contents Model S15 Shown Page Safety Information Example of Antenna Grounding PER National Electric Code NEC Verification Safety SymbolsProtect Your Investment RegistrationPage Table of Contents Page Introduction Package Contents Features Safety PrecautionsUnit Power Capacity Surge Protection Removable Support Feet Front Panel Controls and IndicatorsFront and Rear Panels Up Arrow Push Button Status Push ButtonVacuum Fluorescent Display Overload Status Indicator LOW Battery Status IndicatorLine OK Status Indicator Filtering Status IndicatorDelayed 2 Status Indicator Rear Panel Connectors and Circuit BreakerSetup Push Button Regulating Status IndicatorP q r s Additional Surge Protected COAX/RF Connectors Surge Protected COAX/RF ConnectorsEthernet Surge Protected Jacks Input Power ConnectorCooling Fan Surge Protected Telephone Jacks TEL/DVR/SAT/DSLRemoving the Battery Pack InstallationInstalling the Unit Front Bezel Removal Inserting and Connecting the BatteryInstall the battery retaining bar Performing the System Test Powering On and Connecting EquipmentOUTLET2 on Selftest is on ON-LINE Selftest Screen No External Battery Connected Screen Status Screens Status and Informational ScreensSystem Load Xxxw Load XXX% Source Xxxxxxx EST. Runtime Xhrs Screen Informational ScreensFirmware Version Xxxxxxx Screen Firmware Version Xxxxxxx ScreenPhone Number and Technical Support Internet Address Model Number and Serial Number ScreenInput FREQUENCY/OUTPUT Frequency Screen Connecting the ComponentsS10/S15 Set Up Using Front-Panel Controls Audible Alarm Setting Screen Sensitivity High Setting Screen GO to Battery if Xxxv Setting Screen Lowbattwarning Setting Screen Do Quik Selftest Screen DISPLY-BEEP Test Screen Initialization Complete Limited Warranty Output Technical SpecificationsInput Physical Surge ProtectionPage Unit will not turn on TroubleshootingCircuit breaker has tripped Technical Support Replace Battery LED is illuminatedContact Information Page Page 990-1906D 2007 APC Worldwide Customer Support