American Power Conversion S15BLK owner manual OUTLET2 on

Page 26

Figure 8. Model Identification Screen

DELAYED OUTLET1: ON; DELAYED OUTLET1: OFF screen – this message,

shown in Figure 9, indicates that power is available to the device (TUNER/AUX) that is connected to the rear-panel outlet marked Delayed 1.

It also shows that power is not yet available to the devices that are connected to rear-panel outlets marked Delayed 2 (SUBWOOFER and/or AMPLIFIER). Power to Delayed 2 devices will be available after the factory preset delay (5 seconds) has elapsed. See “Setup the S10 or S15” to change the delay period. Once power is available for Delayed 2 devices, the screen will change to DELAYED

OUTLET2: ON.

Figure 9. DELAYED OUTLET1: ON; DELAYED OUTLET1: OFF Screen

2-6

Image 26

Contents Model S15 Shown Page Safety Information Example of Antenna Grounding PER National Electric Code NEC Registration Safety SymbolsProtect Your Investment VerificationPage Table of Contents Page Introduction Package Contents Features Safety PrecautionsUnit Power Capacity Surge Protection Removable Support Feet Front Panel Controls and IndicatorsFront and Rear Panels Up Arrow Push Button Status Push ButtonVacuum Fluorescent Display Filtering Status Indicator LOW Battery Status IndicatorLine OK Status Indicator Overload Status IndicatorRegulating Status Indicator Rear Panel Connectors and Circuit BreakerSetup Push Button Delayed 2 Status IndicatorP q r s Surge Protected COAX/RF Connectors Additional Surge Protected COAX/RF ConnectorsInput Power Connector Ethernet Surge Protected JacksSurge Protected Telephone Jacks TEL/DVR/SAT/DSL Cooling FanInstallation Removing the Battery PackInstalling the Unit Inserting and Connecting the Battery Front Bezel RemovalInstall the battery retaining bar Powering On and Connecting Equipment Performing the System TestOUTLET2 on Selftest is on ON-LINE Selftest Screen No External Battery Connected Screen Status and Informational Screens Status ScreensSystem Load Xxxw Load XXX% Informational Screens Source Xxxxxxx EST. Runtime Xhrs ScreenFirmware Version Xxxxxxx Screen Firmware Version Xxxxxxx ScreenModel Number and Serial Number Screen Phone Number and Technical Support Internet AddressConnecting the Components Input FREQUENCY/OUTPUT Frequency ScreenS10/S15 Set Up Using Front-Panel Controls Audible Alarm Setting Screen Sensitivity High Setting Screen GO to Battery if Xxxv Setting Screen Lowbattwarning Setting Screen Do Quik Selftest Screen DISPLY-BEEP Test Screen Initialization Complete Limited Warranty Output Technical SpecificationsInput Surge Protection PhysicalPage Troubleshooting Unit will not turn onCircuit breaker has tripped Technical Support Replace Battery LED is illuminatedContact Information Page Page APC Worldwide Customer Support 990-1906D 2007