American Power Conversion S15BLK owner manual No External Battery Connected Screen

Page 28

Figure 12. NO EXTERNAL BATTERY CONNECTED Screen

SELFTEST RESULT; SELFTEST HAS PASSED screen – Figure 13 displays the message TEST HAS PASSED, which indicates that self-test ran successfully to completion. If the message TEST HAS FAILED is displayed, please contact APC Technical Support.

Figure 13. SELFTEST RESULT; SELFTEST HAS PASSED Screen

2-8

Image 28

Contents Model S15 Shown Page Safety Information Example of Antenna Grounding PER National Electric Code NEC Safety Symbols Protect Your InvestmentRegistration VerificationPage Table of Contents Page Introduction Package Contents Unit Power Capacity Safety PrecautionsFeatures Surge Protection Front and Rear Panels Front Panel Controls and IndicatorsRemovable Support Feet Vacuum Fluorescent Display Status Push ButtonUp Arrow Push Button LOW Battery Status Indicator Line OK Status IndicatorFiltering Status Indicator Overload Status IndicatorRear Panel Connectors and Circuit Breaker Setup Push ButtonRegulating Status Indicator Delayed 2 Status IndicatorP q r s Surge Protected COAX/RF Connectors Additional Surge Protected COAX/RF ConnectorsInput Power Connector Ethernet Surge Protected JacksSurge Protected Telephone Jacks TEL/DVR/SAT/DSL Cooling FanInstallation Removing the Battery PackInstalling the Unit Inserting and Connecting the Battery Front Bezel RemovalInstall the battery retaining bar Powering On and Connecting Equipment Performing the System TestOUTLET2 on Selftest is on ON-LINE Selftest Screen No External Battery Connected Screen Status and Informational Screens Status ScreensSystem Load Xxxw Load XXX% Informational Screens Source Xxxxxxx EST. Runtime Xhrs ScreenFirmware Version Xxxxxxx Screen Firmware Version Xxxxxxx ScreenModel Number and Serial Number Screen Phone Number and Technical Support Internet AddressConnecting the Components Input FREQUENCY/OUTPUT Frequency ScreenS10/S15 Set Up Using Front-Panel Controls Audible Alarm Setting Screen Sensitivity High Setting Screen GO to Battery if Xxxv Setting Screen Lowbattwarning Setting Screen Do Quik Selftest Screen DISPLY-BEEP Test Screen Initialization Complete Limited Warranty Input Technical SpecificationsOutput Surge Protection PhysicalPage Troubleshooting Unit will not turn onCircuit breaker has tripped Contact Information Replace Battery LED is illuminatedTechnical Support Page Page APC Worldwide Customer Support 990-1906D 2007