American Power Conversion S15BLK owner manual Install the battery retaining bar

Page 24

3.Push the battery wire connector into the hole located to the left of the battery pack, as shown in Figure 5. Ensure that the battery wire connector is pushed into the hole, and securely connected by gently pulling on the wire to ensure it is attached to the connector.

Figure 5. Battery Wire Connection

Caution: Failure to install the battery retaining bar can be hazardous.

4.Install the battery retaining bar.

5.Install the front bezel, as shown in Figure 6, by aligning the four pins located on the back-side of the bezel with the holes at the left and right sides of the unit. Gently push the front bezel into place.

Figure 6. Front Bezel Installation

2-4

Image 24

Contents Model S15 Shown Page Safety Information Example of Antenna Grounding PER National Electric Code NEC Safety Symbols Protect Your InvestmentRegistration VerificationPage Table of Contents Page Introduction Package Contents Safety Precautions Unit Power CapacityFeatures Surge Protection Front Panel Controls and Indicators Front and Rear PanelsRemovable Support Feet Status Push Button Vacuum Fluorescent DisplayUp Arrow Push Button LOW Battery Status Indicator Line OK Status IndicatorFiltering Status Indicator Overload Status IndicatorRear Panel Connectors and Circuit Breaker Setup Push ButtonRegulating Status Indicator Delayed 2 Status IndicatorP q r s Surge Protected COAX/RF Connectors Additional Surge Protected COAX/RF ConnectorsInput Power Connector Ethernet Surge Protected JacksSurge Protected Telephone Jacks TEL/DVR/SAT/DSL Cooling FanInstallation Removing the Battery PackInstalling the Unit Inserting and Connecting the Battery Front Bezel RemovalInstall the battery retaining bar Powering On and Connecting Equipment Performing the System TestOUTLET2 on Selftest is on ON-LINE Selftest Screen No External Battery Connected Screen Status and Informational Screens Status ScreensSystem Load Xxxw Load XXX% Informational Screens Source Xxxxxxx EST. Runtime Xhrs ScreenFirmware Version Xxxxxxx Screen Firmware Version Xxxxxxx ScreenModel Number and Serial Number Screen Phone Number and Technical Support Internet AddressConnecting the Components Input FREQUENCY/OUTPUT Frequency ScreenS10/S15 Set Up Using Front-Panel Controls Audible Alarm Setting Screen Sensitivity High Setting Screen GO to Battery if Xxxv Setting Screen Lowbattwarning Setting Screen Do Quik Selftest Screen DISPLY-BEEP Test Screen Initialization Complete Limited Warranty Technical Specifications InputOutput Surge Protection PhysicalPage Troubleshooting Unit will not turn onCircuit breaker has tripped Replace Battery LED is illuminated Contact InformationTechnical Support Page Page APC Worldwide Customer Support 990-1906D 2007