American Power Conversion S15BLK owner manual APC Worldwide Customer Support, 990-1906D 2007

Page 52

APC Worldwide Customer Support

Customer support for this or any other APC product is available at no charge in any of the following ways:

Visit the APC Web site to access documents in the APC Knowledge Base and to submit customer support requests.

www.apc.com (Corporate Headquarters)

Connect to localized APC Web sites for specific countries, each of which provides customer support information.

www.apc.com/support/

Global support searching APC Knowledge Base and using e-support.

Contact an APC Customer Support center by telephone or e-mail.

Regional centers

APC headquarters U.S.,

(1)(800)800-4272

Canada

(toll free)

Latin America

(1)(401)789-5735

 

(USA)

Europe, Middle East,

(353)(91)702000

Africa

(Ireland)

Japan

(0) 35434-2021

Australia, New Zealand,

(61) (2) 9955 9366

South Pacific area

(Australia)

Local, country-specific centers, for contact information go to:

www.apc.com/support/contact .

Contact the APC representative or other distributor from whom you purchased your APC product for information on how to obtain local customer support.

Entire contents copyright © 2007 American Power Conversion Corporation. All rights reserved. Reproduction in whole or in part without permission is prohibited. APC, the APC logo, and TRADE MARK NAMES are trademarks of American Power Conversion Corporation.

All other trademarks, product names, and corporate names are the property of their respective owners and are used for informational purposes only.

990-1906D

4/2007

Image 52
Contents Model S15 Shown Page Safety Information Example of Antenna Grounding PER National Electric Code NEC Safety Symbols Protect Your InvestmentRegistration VerificationPage Table of Contents Page Introduction Package Contents Unit Power Capacity Safety PrecautionsFeatures Surge Protection Front and Rear Panels Front Panel Controls and IndicatorsRemovable Support Feet Vacuum Fluorescent Display Status Push ButtonUp Arrow Push Button LOW Battery Status Indicator Line OK Status IndicatorFiltering Status Indicator Overload Status IndicatorRear Panel Connectors and Circuit Breaker Setup Push ButtonRegulating Status Indicator Delayed 2 Status IndicatorP q r s Surge Protected COAX/RF Connectors Additional Surge Protected COAX/RF ConnectorsInput Power Connector Ethernet Surge Protected JacksSurge Protected Telephone Jacks TEL/DVR/SAT/DSL Cooling FanInstallation Removing the Battery PackInstalling the Unit Inserting and Connecting the Battery Front Bezel RemovalInstall the battery retaining bar Powering On and Connecting Equipment Performing the System TestOUTLET2 on Selftest is on ON-LINE Selftest Screen No External Battery Connected Screen Status and Informational Screens Status ScreensSystem Load Xxxw Load XXX% Informational Screens Source Xxxxxxx EST. Runtime Xhrs ScreenFirmware Version Xxxxxxx Screen Firmware Version Xxxxxxx ScreenModel Number and Serial Number Screen Phone Number and Technical Support Internet AddressConnecting the Components Input FREQUENCY/OUTPUT Frequency ScreenS10/S15 Set Up Using Front-Panel Controls Audible Alarm Setting Screen Sensitivity High Setting Screen GO to Battery if Xxxv Setting Screen Lowbattwarning Setting Screen Do Quik Selftest Screen DISPLY-BEEP Test Screen Initialization Complete Limited Warranty Input Technical SpecificationsOutput Surge Protection PhysicalPage Troubleshooting Unit will not turn onCircuit breaker has tripped Contact Information Replace Battery LED is illuminatedTechnical Support Page Page APC Worldwide Customer Support 990-1906D 2007