American Power Conversion S15BLK owner manual Installation, Removing the Battery Pack

Page 21

C h a p t e r 2

Installation

This chapter contains the following procedures:

•Removing the Battery Pack

•Installing the Unit

•Inserting and Connecting the Battery

•Powering On and Connecting Equipment

•Performing the System Test

•Status and Informational Screens

•Connecting the Components

•S10/S15 Set Up Using Front-Panel Controls

Removing the Battery Pack

1.Remove the battery retaining bar.

2.Pull the battery straight back.

3.Push in the retaining tabs to allow the battery to come out completely.

2-1

Image 21

Contents Model S15 Shown Page Safety Information Example of Antenna Grounding PER National Electric Code NEC Protect Your Investment Safety SymbolsRegistration VerificationPage Table of Contents Page Introduction Package Contents Safety Precautions Unit Power CapacityFeatures Surge Protection Front Panel Controls and Indicators Front and Rear PanelsRemovable Support Feet Status Push Button Vacuum Fluorescent DisplayUp Arrow Push Button Line OK Status Indicator LOW Battery Status IndicatorFiltering Status Indicator Overload Status IndicatorSetup Push Button Rear Panel Connectors and Circuit BreakerRegulating Status Indicator Delayed 2 Status IndicatorP q r s Additional Surge Protected COAX/RF Connectors Surge Protected COAX/RF ConnectorsEthernet Surge Protected Jacks Input Power ConnectorCooling Fan Surge Protected Telephone Jacks TEL/DVR/SAT/DSLRemoving the Battery Pack InstallationInstalling the Unit Front Bezel Removal Inserting and Connecting the BatteryInstall the battery retaining bar Performing the System Test Powering On and Connecting EquipmentOUTLET2 on Selftest is on ON-LINE Selftest Screen No External Battery Connected Screen Status Screens Status and Informational ScreensSystem Load Xxxw Load XXX% Source Xxxxxxx EST. Runtime Xhrs Screen Informational ScreensFirmware Version Xxxxxxx Screen Firmware Version Xxxxxxx ScreenPhone Number and Technical Support Internet Address Model Number and Serial Number ScreenInput FREQUENCY/OUTPUT Frequency Screen Connecting the ComponentsS10/S15 Set Up Using Front-Panel Controls Audible Alarm Setting Screen Sensitivity High Setting Screen GO to Battery if Xxxv Setting Screen Lowbattwarning Setting Screen Do Quik Selftest Screen DISPLY-BEEP Test Screen Initialization Complete Limited Warranty Technical Specifications InputOutput Physical Surge ProtectionPage Unit will not turn on TroubleshootingCircuit breaker has tripped Replace Battery LED is illuminated Contact InformationTechnical Support Page Page 990-1906D 2007 APC Worldwide Customer Support