American Power Conversion S15BLK owner manual System Load Xxxw Load XXX%

Page 30

SYSTEM LOAD: <XXXW; LOAD: <XXX%

This screen is shown in Figure 15. The S10 and S15 can also display the value (load) of the connected equipment in watts, and as a percentage of the total allowable load connected to the unit. Loads less than 5% of rated load (35 watts for the S10; 45watts for the S15) will be displayed as < 5%.

Figure 15. SYSTEM LOAD: <XXXW; LOAD: <XXX% Screen

EST. RUNTIME: XHRS; FUEL: XXX%

This screen is shown in Figure 16. Each unit can also display the estimated runtime as EST. RUNTIME (in hours), as well as the FUEL capacity of the internal battery pack (as a percentage) based on the total load connected to the device. If the estimated runtime is < 1 hour, the EST. RUNTIME will show in minutes.

Figure 16. EST. RUNTIME: XHRS; FUEL: XXX% Screen

Note: For your convenience, you can set the unit to display any of the screens as the “default” screen. The default screen is the screen that the system will return to once the preset time has expired for other screens that are being displayed. APC recommends that you set the default screen to show the EST. RUNTIME and FUEL values, shown in Figure 16.

2-10

Image 30

Contents Model S15 Shown Page Safety Information Example of Antenna Grounding PER National Electric Code NEC Registration Safety SymbolsProtect Your Investment VerificationPage Table of Contents Page Introduction Package Contents Safety Precautions Unit Power CapacityFeatures Surge Protection Front Panel Controls and Indicators Front and Rear PanelsRemovable Support Feet Status Push Button Vacuum Fluorescent DisplayUp Arrow Push Button Filtering Status Indicator LOW Battery Status IndicatorLine OK Status Indicator Overload Status IndicatorRegulating Status Indicator Rear Panel Connectors and Circuit BreakerSetup Push Button Delayed 2 Status IndicatorP q r s Surge Protected COAX/RF Connectors Additional Surge Protected COAX/RF ConnectorsInput Power Connector Ethernet Surge Protected JacksSurge Protected Telephone Jacks TEL/DVR/SAT/DSL Cooling FanInstallation Removing the Battery PackInstalling the Unit Inserting and Connecting the Battery Front Bezel RemovalInstall the battery retaining bar Powering On and Connecting Equipment Performing the System TestOUTLET2 on Selftest is on ON-LINE Selftest Screen No External Battery Connected Screen Status and Informational Screens Status ScreensSystem Load Xxxw Load XXX% Informational Screens Source Xxxxxxx EST. Runtime Xhrs ScreenFirmware Version Xxxxxxx Screen Firmware Version Xxxxxxx ScreenModel Number and Serial Number Screen Phone Number and Technical Support Internet AddressConnecting the Components Input FREQUENCY/OUTPUT Frequency ScreenS10/S15 Set Up Using Front-Panel Controls Audible Alarm Setting Screen Sensitivity High Setting Screen GO to Battery if Xxxv Setting Screen Lowbattwarning Setting Screen Do Quik Selftest Screen DISPLY-BEEP Test Screen Initialization Complete Limited Warranty Technical Specifications InputOutput Surge Protection PhysicalPage Troubleshooting Unit will not turn onCircuit breaker has tripped Replace Battery LED is illuminated Contact InformationTechnical Support Page Page APC Worldwide Customer Support 990-1906D 2007