American Power Conversion S15BLK owner manual Sensitivity High Setting Screen

Page 37

Figure 23. SENSITIVITY (HIGH) Setting Screen

DISPLAY DIMMER Setting – This lets you set a brightness level for the VFD of HIGH, LOW, or OFF. Use the SETUP pushbutton to advance to the Display Dimmer screen (shown in Figure 24). Once the display is shown, repeatedly pressing the Up or Down Arrow pushbutton allows you to set the brightness of the display. Once the display brightness is to the desired value, press the SETUP pushbutton to store the setting.

Note: Even when the display dimmer is set to OFF, the screen will turn back on momentarily when there is a significant change in system status, such as a power outage or a low battery condition.

Figure 24. DISPLAY DIMMER (HIGH) Setting Screen

LED DIMMER Setting – This lets you set a brightness level for the front-panel light emitting diode (LED) indicators of HIGH, LOW, or OFF. Use the SETUP pushbutton to advance to the LED DIMMER screen (not shown). Once the display is shown, press the Up Arrow and Down Arrow pushbuttons to set the brightness level of the LEDs.

2-17

Image 37

Contents Model S15 Shown Page Safety Information Example of Antenna Grounding PER National Electric Code NEC Protect Your Investment Safety SymbolsRegistration VerificationPage Table of Contents Page Introduction Package Contents Unit Power Capacity Safety PrecautionsFeatures Surge Protection Front and Rear Panels Front Panel Controls and IndicatorsRemovable Support Feet Vacuum Fluorescent Display Status Push ButtonUp Arrow Push Button Line OK Status Indicator LOW Battery Status IndicatorFiltering Status Indicator Overload Status IndicatorSetup Push Button Rear Panel Connectors and Circuit BreakerRegulating Status Indicator Delayed 2 Status IndicatorP q r s Additional Surge Protected COAX/RF Connectors Surge Protected COAX/RF ConnectorsEthernet Surge Protected Jacks Input Power ConnectorCooling Fan Surge Protected Telephone Jacks TEL/DVR/SAT/DSLRemoving the Battery Pack InstallationInstalling the Unit Front Bezel Removal Inserting and Connecting the BatteryInstall the battery retaining bar Performing the System Test Powering On and Connecting EquipmentOUTLET2 on Selftest is on ON-LINE Selftest Screen No External Battery Connected Screen Status Screens Status and Informational ScreensSystem Load Xxxw Load XXX% Source Xxxxxxx EST. Runtime Xhrs Screen Informational ScreensFirmware Version Xxxxxxx Screen Firmware Version Xxxxxxx ScreenPhone Number and Technical Support Internet Address Model Number and Serial Number ScreenInput FREQUENCY/OUTPUT Frequency Screen Connecting the ComponentsS10/S15 Set Up Using Front-Panel Controls Audible Alarm Setting Screen Sensitivity High Setting Screen GO to Battery if Xxxv Setting Screen Lowbattwarning Setting Screen Do Quik Selftest Screen DISPLY-BEEP Test Screen Initialization Complete Limited Warranty Input Technical SpecificationsOutput Physical Surge ProtectionPage Unit will not turn on TroubleshootingCircuit breaker has tripped Contact Information Replace Battery LED is illuminatedTechnical Support Page Page 990-1906D 2007 APC Worldwide Customer Support