American Power Conversion S15BLK owner manual Status Push Button, Vacuum Fluorescent Display

1DELAYED 1 Status Indicator

2

3

4

5

When lit (blue), conditioned power is being supplied to equipment connected to the rear-panel outlets marked Delayed 1.

ON BATTERY Status Indicator

When lit (orange), the Power Conditioner is operating on power from the internal Battery Pack and is providing clean power to the connected equipment. The unit will go On Battery when the input utility voltage either drops below the user-selectable level, goes above the user-selectable level, or is experiences an outage, or momentary input utility voltage drops or surges.

STATUS Push Button

When you press this pushbutton, it provides the unit status for: Input and Output Voltage, Input and Output Frequency, Telephone and Internet contact information, Model and Serial Number, Firmware (FW) Version number, Source (Standby, Battery, or Utility), Estimated Runtime (in hours or minutes), and Estimated Runtime (in hours) with a Fuel indication (as a percentage with bar graph) indication, as well as System Load (in watts), and Load (as a percentage in bar graph form).

This push button can also be used to set a default screen, which is a screen that is automatically displayed all the time.

Vacuum Fluorescent Display*

The vacuum flourescent display (VFD) conveys information about unit and power status. It is also used to display information when changing unit settings.

Note: The VFD and light emitting diodes (LEDs) can be dimmed or turned off independently of each other via the front control panel SETUP push button.

Up Arrow Push Button

This button is used to increase or turn on parameters for various user-selectable settings such as: Audible Alarms, Sensitivity, Display Dimmer, LED Dimmer, Go To Bat If, Outlet 1 & 2 Delay (in seconds), Low Bat Warning, and so on.

1-6