Note: The display will revert to the default informational screen after about 30 seconds of inactivity. To change the default informational screen, first press the STATUS button until the desired screen is displayed. Then press the STATUS button down for approximately 3 seconds until the screen displays CURRENT SCREEN IS SAVED AS DEFAULT.
The SOURCE: XXXXXXX; EST. RUNTIME: XHRS screen, is as shown in Figure 17 below.
Figure 17. Default SOURCE: XXXXXXX; EST. RUNTIME: XHRS Screen
Informational Screens
The S10 and S15 Power Conditioners with Battery Backup provide the following informational screens, which are accessed using the STATUS pushbutton:
•Source: XXXXXXX screen
•FW Version: XXXXXXX screen
•Model Number and Serial Number screen
•Phone Number and Technical Support Internet Address screen
•Input Frequency; Output Frequency screen
SOURCE: XXXXXXX; EST. RUNTIME: XHRS Screen
This screen, shown previously in Figure 17, indicates which type of source the unit is deriving power from (UTILITY, BATTERY, or STANDBY). It also displays the EST. RUNTIME (in hours) based on the power source, and connected equipment LOAD. In Standby mode, the unit does not provide an output to the rear panel outlets.
Note: Whenever the S10 or S15 is connected to utility power, the electronics inside of each unit are active. If the front panel Power Switch is turned off, the unit goes into Standby mode and shuts off power to the