American Power Conversion S15BLK owner manual Selftest is on ON-LINE Selftest Screen

Page 27

SELFTEST IS ON; ON-LINE SELFTEST screen – this screen, shown in Figure 10, indicates that Selftest is on, and On-Line Selftest is active. This Selftest is conducted using utility power.

Figure 10. SELFTEST IS ON; ON-LINE SELFTEST Screen

SELFTEST IS ON; ON-BATTERY SELFTEST screen – Figure 11 shows that an ON-BATTERY SELFTEST is active with the unit internally switched to derive power from the internal battery pack, which should already be connected within the unit. The ON BATTERY LED is also lit (on) during this test. The unit will also test to determine if an optional external battery pack (Model SBATT) is connected to the unit. If no external battery pack is connected to the unit, the message NO EXTERNAL BATTERY CONNECTED) will be displayed, as shown in Figure 12.

Figure 11. SELFTEST IS ON; ON-BATTERY SELFTEST Screen

2-7

Image 27

Contents Model S15 Shown Page Safety Information Example of Antenna Grounding PER National Electric Code NEC Verification Safety SymbolsProtect Your Investment RegistrationPage Table of Contents Page Introduction Package Contents Safety Precautions Unit Power CapacityFeatures Surge Protection Front Panel Controls and Indicators Front and Rear PanelsRemovable Support Feet Status Push Button Vacuum Fluorescent DisplayUp Arrow Push Button Overload Status Indicator LOW Battery Status IndicatorLine OK Status Indicator Filtering Status IndicatorDelayed 2 Status Indicator Rear Panel Connectors and Circuit BreakerSetup Push Button Regulating Status IndicatorP q r s Additional Surge Protected COAX/RF Connectors Surge Protected COAX/RF ConnectorsEthernet Surge Protected Jacks Input Power ConnectorCooling Fan Surge Protected Telephone Jacks TEL/DVR/SAT/DSLRemoving the Battery Pack InstallationInstalling the Unit Front Bezel Removal Inserting and Connecting the BatteryInstall the battery retaining bar Performing the System Test Powering On and Connecting EquipmentOUTLET2 on Selftest is on ON-LINE Selftest Screen No External Battery Connected Screen Status Screens Status and Informational ScreensSystem Load Xxxw Load XXX% Source Xxxxxxx EST. Runtime Xhrs Screen Informational ScreensFirmware Version Xxxxxxx Screen Firmware Version Xxxxxxx ScreenPhone Number and Technical Support Internet Address Model Number and Serial Number ScreenInput FREQUENCY/OUTPUT Frequency Screen Connecting the ComponentsS10/S15 Set Up Using Front-Panel Controls Audible Alarm Setting Screen Sensitivity High Setting Screen GO to Battery if Xxxv Setting Screen Lowbattwarning Setting Screen Do Quik Selftest Screen DISPLY-BEEP Test Screen Initialization Complete Limited Warranty Technical Specifications InputOutput Physical Surge ProtectionPage Unit will not turn on TroubleshootingCircuit breaker has tripped Replace Battery LED is illuminated Contact InformationTechnical Support Page Page 990-1906D 2007 APC Worldwide Customer Support