American Power Conversion S15BLK Performing the System Test, Powering On and Connecting Equipment

Page 25

Powering On and Connecting Equipment

1.Power on the S10/S15 unit.

2.Connect the equipment.

3.Connect the data line cables.

4.Power on the connected equipment.

Performing the System Test

Before connecting equipment to the S10 or S15 Power Conditioner with Battery Backup, ensure that the unit is functional by connecting the AC Power Cord (provided) at the rear panel. Press the front panel power switch. Once power is applied to the unit, the display provides the information screens shown in Figures 7 through 15, and defined as follows:

APC - LEGENDARY RELIABILITY screen — this screen, shown in Figure 7, indicates that the unit has power and is functioning.

Figure 7. APC - LEGENDARY RELIABILITY Screen

Model Identification screen – the message displayed in Figure 8 indicates that the proper firmware was installed for the model purchased.

2-5

Image 25

Contents Model S15 Shown Page Safety Information Example of Antenna Grounding PER National Electric Code NEC Protect Your Investment Safety SymbolsRegistration VerificationPage Table of Contents Page Introduction Package Contents Unit Power Capacity Safety PrecautionsFeatures Surge Protection Front and Rear Panels Front Panel Controls and IndicatorsRemovable Support Feet Vacuum Fluorescent Display Status Push ButtonUp Arrow Push Button Line OK Status Indicator LOW Battery Status IndicatorFiltering Status Indicator Overload Status IndicatorSetup Push Button Rear Panel Connectors and Circuit BreakerRegulating Status Indicator Delayed 2 Status IndicatorP q r s Additional Surge Protected COAX/RF Connectors Surge Protected COAX/RF ConnectorsEthernet Surge Protected Jacks Input Power ConnectorCooling Fan Surge Protected Telephone Jacks TEL/DVR/SAT/DSLRemoving the Battery Pack InstallationInstalling the Unit Front Bezel Removal Inserting and Connecting the BatteryInstall the battery retaining bar Performing the System Test Powering On and Connecting EquipmentOUTLET2 on Selftest is on ON-LINE Selftest Screen No External Battery Connected Screen Status Screens Status and Informational ScreensSystem Load Xxxw Load XXX% Source Xxxxxxx EST. Runtime Xhrs Screen Informational ScreensFirmware Version Xxxxxxx Screen Firmware Version Xxxxxxx ScreenPhone Number and Technical Support Internet Address Model Number and Serial Number ScreenInput FREQUENCY/OUTPUT Frequency Screen Connecting the ComponentsS10/S15 Set Up Using Front-Panel Controls Audible Alarm Setting Screen Sensitivity High Setting Screen GO to Battery if Xxxv Setting Screen Lowbattwarning Setting Screen Do Quik Selftest Screen DISPLY-BEEP Test Screen Initialization Complete Limited Warranty Input Technical SpecificationsOutput Physical Surge ProtectionPage Unit will not turn on TroubleshootingCircuit breaker has tripped Contact Information Replace Battery LED is illuminatedTechnical Support Page Page 990-1906D 2007 APC Worldwide Customer Support