American Power Conversion S15BLK owner manual S10/S15 Set Up Using Front-Panel Controls

Page 35

S10/S15 Set Up Using Front-Panel Controls

You can use the front panel SETUP and Arrow Up/Down pushbuttons to configure (or turn on/off) various functions provided by each S Type unit. When you press the SETUP pushbutton, the unit functions are displayed in the following order:

1.Audible Alarm

2.Sensitivity, Display Dimmer

3.LED Dimmer

4.Go To Battery If <XX Volts, Go To Battery if >XX Volts

5.Outlet Delay1

6.Outlet Delay2

7.Low Battery Warning

8.Battery Replacement Date

9.Do Quick Selftest

10.Do Runtime Calculation

11.Display Beep Test

12.Screen Saver On/Off, or Reset to Default

2-15

Image 35

Contents Model S15 Shown Page Safety Information Example of Antenna Grounding PER National Electric Code NEC Verification Safety SymbolsProtect Your Investment RegistrationPage Table of Contents Page Introduction Package Contents Features Safety PrecautionsUnit Power Capacity Surge Protection Removable Support Feet Front Panel Controls and IndicatorsFront and Rear Panels Up Arrow Push Button Status Push ButtonVacuum Fluorescent Display Overload Status Indicator LOW Battery Status IndicatorLine OK Status Indicator Filtering Status IndicatorDelayed 2 Status Indicator Rear Panel Connectors and Circuit BreakerSetup Push Button Regulating Status IndicatorP q r s Additional Surge Protected COAX/RF Connectors Surge Protected COAX/RF ConnectorsEthernet Surge Protected Jacks Input Power ConnectorCooling Fan Surge Protected Telephone Jacks TEL/DVR/SAT/DSLRemoving the Battery Pack InstallationInstalling the Unit Front Bezel Removal Inserting and Connecting the BatteryInstall the battery retaining bar Performing the System Test Powering On and Connecting EquipmentOUTLET2 on Selftest is on ON-LINE Selftest Screen No External Battery Connected Screen Status Screens Status and Informational ScreensSystem Load Xxxw Load XXX% Source Xxxxxxx EST. Runtime Xhrs Screen Informational ScreensFirmware Version Xxxxxxx Screen Firmware Version Xxxxxxx ScreenPhone Number and Technical Support Internet Address Model Number and Serial Number ScreenInput FREQUENCY/OUTPUT Frequency Screen Connecting the ComponentsS10/S15 Set Up Using Front-Panel Controls Audible Alarm Setting Screen Sensitivity High Setting Screen GO to Battery if Xxxv Setting Screen Lowbattwarning Setting Screen Do Quik Selftest Screen DISPLY-BEEP Test Screen Initialization Complete Limited Warranty Output Technical SpecificationsInput Physical Surge ProtectionPage Unit will not turn on TroubleshootingCircuit breaker has tripped Technical Support Replace Battery LED is illuminatedContact Information Page Page 990-1906D 2007 APC Worldwide Customer Support