American Power Conversion S15BLK Protect Your Investment, Safety Symbols, Registration

Page 5

Protect Your Investment

Thank you for selecting APC's S Type Power Conditioner with Battery Backup. We at APC know you have made an intelligent choice sure to reward you for many years. To ensure you receive all the benefits and protection that accompany your purchase, please take a few minutes to fill out and mail the enclosed Warranty Registration Card, or complete the online form at www.apcav.com.

Note: Under California law, failure to register your purchase may not exclude you from provisions of the Warranty and Equipment Protection Policy. The benefits of warranty registration are outlined below.

Registration

Registering your pur- chase now guaran- tees that you will receive all the informa- tion and special offers you qualify for as the owner of this product.

Verification

Registering your pur- chase now confirms your right to maximum protection under the terms and conditions of the Warranty, and Equipment Protection Policy.

Confirmation

Registering your pur- chase now provides you with a way to con- firm yourself as the owner of the product in the event of fire, theft or loss.

Safety Symbols

This “bolt of lightning” indicates uninsulated material within your unit that may cause an electri- cal shock. For the safety of everyone in your home, please do not remove the product cover.

!This “exclamation point” symbol calls attention to features for which you should read about in this Manual to avoid operating and maintenance prob- lems.

Warnings, Cautions and Notes

Warnings

Warnings provide information about a procedure that, if not performed exactly as stated, may result in injury or death.

Cautions

Cautions provide information about a procedure that, if not performed exactly as stated, may result in equip- ment damage.

Notes

Notes provide information that is essential to high- light.

iii

Image 5
Contents Model S15 Shown Page Safety Information Example of Antenna Grounding PER National Electric Code NEC Protect Your Investment Safety SymbolsRegistration VerificationPage Table of Contents Page Introduction Package Contents Features Safety PrecautionsUnit Power Capacity Surge Protection Removable Support Feet Front Panel Controls and IndicatorsFront and Rear Panels Up Arrow Push Button Status Push ButtonVacuum Fluorescent Display Line OK Status Indicator LOW Battery Status IndicatorFiltering Status Indicator Overload Status IndicatorSetup Push Button Rear Panel Connectors and Circuit BreakerRegulating Status Indicator Delayed 2 Status IndicatorP q r s Additional Surge Protected COAX/RF Connectors Surge Protected COAX/RF ConnectorsEthernet Surge Protected Jacks Input Power ConnectorCooling Fan Surge Protected Telephone Jacks TEL/DVR/SAT/DSLRemoving the Battery Pack InstallationInstalling the Unit Front Bezel Removal Inserting and Connecting the BatteryInstall the battery retaining bar Performing the System Test Powering On and Connecting EquipmentOUTLET2 on Selftest is on ON-LINE Selftest Screen No External Battery Connected Screen Status Screens Status and Informational ScreensSystem Load Xxxw Load XXX% Source Xxxxxxx EST. Runtime Xhrs Screen Informational ScreensFirmware Version Xxxxxxx Screen Firmware Version Xxxxxxx ScreenPhone Number and Technical Support Internet Address Model Number and Serial Number ScreenInput FREQUENCY/OUTPUT Frequency Screen Connecting the ComponentsS10/S15 Set Up Using Front-Panel Controls Audible Alarm Setting Screen Sensitivity High Setting Screen GO to Battery if Xxxv Setting Screen Lowbattwarning Setting Screen Do Quik Selftest Screen DISPLY-BEEP Test Screen Initialization Complete Limited Warranty Output Technical SpecificationsInput Physical Surge ProtectionPage Unit will not turn on TroubleshootingCircuit breaker has tripped Technical Support Replace Battery LED is illuminatedContact Information Page Page 990-1906D 2007 APC Worldwide Customer Support