USING A MOUNTING FIXTURE
Cintiq can be attached to any mounting fixture conforming to the VESA 75 standard. This requires four M4 Regular screws (4 mm diameter with 0.7 mm pitch) with a clearance depth of no more than 6 mm.
Exceeding the screw length may result in damage to the display.
Attaching to a fixture:
1.Turn off your computer and power off Cintiq. Disconnect the power cable from the converter unit, and then the Cintiq cable from the converter unit.
2.Close the Cintiq stand and place the unit face down on a flat, soft surface (such as a cloth spread across a desktop).
3.Firmly attach Cintiq to the fixture using four M4 Regular screws (4 mm diameter with 0.7 mm pitch).
Important: Make sure the screw clearance depth does not exceed 6 mm, or the screws will damage the Cintiq.
CAUTION When attaching Cintiq onto a VESA standard fixture, be sure to follow all instructions 
in the documentation supplied by the fixture manufacturer. If improperly secured, the unit could fall, resulting in damage to the unit or physical injury.
4. Reattach the Cintiq cable to the converter unit.
Removal from the fixture:
To remove the fixture at a later time, reverse the above steps.
Appendix
Page 52