Toshiba IPE002Z instruction manual Parameters, Communication parameters

E6581741

3. Parameters

3.1. Communication parameters

Set up the inverter parameters as follows. It is necessary to reset the inverter to update the parameter. This option doesn't operate if these parameters are not correctly set.

Title	Communi	Function	Description	Factory
	cation No.			setting
			0: Terminal board
			1: Panel keypad (including remote keypad)	1
cmod	0003	Command mode selection	2: RS485 communication
			3: CANopen communication
			4: Communcation option
			0: Setting dial 1 (save even if power is off)
			1: Terminal board VIA
			2: Terminal board VIB
			3: Setting dial 2 (press in center to save)
			4: RS485 communication
		Frequency setting mode	5: UP/DOWN from external logic input	0
fmod	0004		6: CANopen communication
		selection 1
			7: Communication option
			8: Terminal board VIC
			9, 10: -
			11: Pulse train input
			12, 13: - (*1)
			14: sr0 (*1)
			1: 2 poles
			2: 4 poles
			3: 6 poles
f856	0856	Number of motor pole pair for	4: 8 poles	2
		communication	5: 10 poles
			6: 12 poles
			7: 14 poles
			8: 16 poles
f899	0899	Communication function reset	0: -	0
			1: Reset (after execution: 0)
(*1): There selections are effective in only VF-S15.
Title	Communi	Function	Description	Factory
	cation No.			setting
			0: -	1
			1: fa06 (Communication command 1)
			2: fa23 (Communication command 2)
			3: fa07 (Frequency command, 0.01Hz)
			5: fa50 (Terminal output data)
c001	C001	Scanner input 1 address (*3)	6: fa51 (FM analog output)
			8: f601 (Stall prevention level, %)
			13: acc (Acceleration time 1, 0.1s) (*2)
			14: dec (Deceleration time 1, 0.1s) (*2)
			15: ul (Upper limit, 0.01Hz)
			16: vb (Torque boost value 1, 0.1%)
			17: vlv (Base frequency voltage 1, 0.1V)
c002	C002	Scanner input 2 address (*3)	0-17 (Same as c001)	3
c003	C003	Scanner input 3 address (*3)	0-17 (Same as c001)	0
c004	C004	Scanner input 4 address (*3)	0-17 (Same as c001)	0
c005	C005	Scanner input 5 address (*3)	0-17 (Same as c001)	0
c006	C006	Scanner input 6 address (*3)	0-17 (Same as c001)	0

(*2): The unit depends on the f519 setting.

(*3): This parameter is effective by reset. Please reset (power supply reset or f899=1) after changing a set point.

- 7 -