Brother FAX-202, FAX-222 owner manual Changing Fax Forwarding

	Remote Commands	Operation Details
95	Changing Fax Forwarding/	If you hear one long beep, the change is
	Paging Setting	accepted. If you hear three short beeps, you
		cannot change it because the conditions have
	1 OFF
		not been met (Example: registering paging
	2 Fax Forwarding
		number). You can register your fax forwarding
	3 Paging	number by using 4. FAX FWD NO. (See page
		9-12.)Once you have registered the number,
	4 FAX FWD NO.
		the fax machine will change automatically to
		FAXFWD:ON mode. Then retrieve a Memory
		Status List by entering 9 6 1 (See page 9-11.)
		to make sure that the Fax Forwarding number
		you registered is correct in the List.
96	Retrieve a fax
	1 Memory Status List	Enter the number of a remote fax machine to
		receive a report or stored fax messages. (See
	2 Retrieve all faxes
		page 9-11.)
	3 Erase fax in the memory	If you hear one long beep, you can erase the fax
		message from the memory.
97 Check the receiving status		You can check whether your fax machine has
		received any FAX or VOICE messages. If yes,
	1 FAX
		you will hear one long beep. If no, you will
	2 VOICE
		hear three short beeps.
98	Change Answer Mode	If you hear one long beep, you can change the
		answer mode. If you hear three short beeps,
	1 MSG CTR
		you cannot change it. (Example: There is no
	2 FAX/TEL
		MSG CTR OGM when you want to change to
	3 FAX	MSG CTR mode.)
90	Exit	After a long beep, you can exit remote control.

9 - 10 M E S S A G E C E N T E R ( F O R F A X - 3 3 3 M C O N L Y )