Microsoft 2045 appendix Separation and Length Reduction, Reverse Order Printing

Reception Features

5

88

Page Separation and Length Reduction

When the size of a received message is longer than the paper loaded in the machine, each page of the message can be split and printed on several sheets, or reduced and printed on a single sheet. For example, this function splits the message if the message length is 20

mm(0.79") or longer than the paper used. The message is reduced if it is less than 20 mm (0.79"). When a mes- sage is split, an asterix (*) is inserted at the split position and about 10 mm (0.39") of the split area is duplicated on the top of the second sheet.

Note

❒Your service representative can customize this function with the following settings:

•Reduction

•Print split mark

•Overprinting

•Overprinting length

•Guideline for split

❒You can adjust the overprinting and reduction lengths within the following ranges:

•Overprinting length: 4 mm (0.16"), 10 mm (0.39"), 15 mm (0.59")

•Guideline for split: 5-155 mm (5 mm steps)/0.2"-6.1" (0.2" steps)

Reverse Order Printing

Normally, received pages are printed and stacked on the tray in the order they are received. If you turn this function on, the machine will start printing the message from the last page received.

Note

❒You can turn this function on or off using Reception Setting. See p.132 “Reception Setting”.

❒When this function is on, the first page will be printed last.

❒This function uses Memory Recep- tion.