Microsoft 2045 appendix Stamp, Press Print File or Print 1st

Other Transmission Features

E Press [Print File] or [Print 1st Page].

When [Print File] is pressed, the ma- chine prints all the pages. When [Print 1st Page] is pressed, the ma- chine prints only the first page.

Limitation

❒When [Print 1st Page] is selected, originals larger than A4 size are printed after they are reduced to A4 size.

❒The machine can print up to 30

4	files using the Print 1st Page
	function.
	Note

❒To print both sides, press [Print 2 Sides].

F Press the {Start} key.

Note

❒When only the first page is printed, the file name is printed at the top of the paper.

❒To cancel printing, press [Can- cel].

G Press [Exit].

Note

❒You can also send a stored doc- ument . See p . 61 “Sending stored documents”.

H Press [OK].

The standby display appears.

Stamp

The optional Auto Document Feeder (ADF) is required.

When sending a fax message using the ADF, the machine can stamp a cir- cle mark at the bottom of the original. When sending a two-sided docu- ment, the document is marked at the bottom of the front page and top of the rear page. This stamp indicates that the original has been successfully stored in memory for Memory Trans- mission, or successfully sent by Im- mediate Transmission.

Note

❒Stamp only works when scanning from the ADF.

❒When the stamp starts getting lighter, replace the cartridge. See p.177 “Replacing the Stamp Car- tridge”.

❒If a page was not stamped even though the Stamp function is turned on, you need to resend that page.

66