PCI Ethernet and Fast Ethernet Adapters
8 Under Protocols, highlight the desired network protocol(s) and click Add.
9 Click Edit to change the ANA-6944A/TX configuration settings, if desired.
If you selected IBM NetWare Requester Support from the Protocols box, you need to make the following configuration changes:
– In the Current Configuration box, highlight IBM NetWare Requester and select Edit.
– Change the Token-Ring Support Option to NO.
– Enable one more of the listed Ethernet frame types by specifying YES in the appropriate boxes. (If you are not sure which frame type(s) are used on your NetWare network, enable all of them).
– Change the Network Adapter Address to the Ethernet address of your Adaptec adapter.
You can run emdiag.exe from your Adaptec driver diskette at an OS/2 command line prompt, and choose Configuration Status, to display your adapter's Ethernet address.
10Make the changes and click OK.
11In the Configure dialog box, select Close.
12In the
13Select Update CONFIG.SYS and then select Exit.
14Shut down OS/2 and reboot for your network driver and protocol(s) to take effect.
Installing OS/2 SMP for the First Time
Follow these instructions if you are installing OS/2 SMP or OS/2 Peer client for the first time.
1Follow the general installation instructions provided with OS/2 SMP to begin your installation.
2During the installation, specify the type(s) of networks you are using.
PCI Ethernet and Fast Ethernet Adapters User’s Guide
Stock Number: | Page: |
Print Spec Number: |
|
Current Date: 5/5/97 | ECN Date: 5/97 |