PCI Ethernet and Fast Ethernet Adapters
SCO Unixware SMP
The
Installing the Drivers
1Insert the Unix Drivers diskette into the first floppy drive (usually A).
2Make a directory for the driver, as follows:
mkdir adaptec
3Change to the directory you just created, as follows: chdir adaptec
4Copy the files from the floppy diskette to the hard disk, as follows:
doscp a:\unixware\*.*.
5Extract the files, as follows:
tar
6To install the drivers, type:
./Install
The system loads the EMPCI modules and displays the following messages:
ADAPTEC: Adaptec (10/100) PCI Fast Ethernet
Installation
ADAPTEC: Please Enter the Card you are Installing (1/2)
1.Adaptec
2.Adaptec
7Enter the number (1 or 2, as shown above) of the adapter you are installing. The system displays the following messages:
ADAPTEC: Netinfo EMPCI_0 EMPCI_1 EMPCI_2 EMPCI_3
ADAPTEC: Please use /etc/confnet.d/configure
PCI Ethernet and Fast Ethernet Adapters User’s Guide
Stock Number: | Page: |
Print Spec Number: |
|
Current Date: 5/5/97 | ECN Date: 5/97 |