3Open the rear cover to use the rear output slot.
2
CAUTION:
•The fusing area inside the rear part of your machine becomes hot once the machine is turned on. Be careful when you access this area.
4After copying, close the rear cover.
Setting the Paper Type and Size for the Manual Feeder
After loading paper in the manual feeder, you need to set the correct paper type and size using the control panel buttons.
To set the paper size for the manual feeder:
1Press Menu.
The display shows “Paper Setting” on the top line and the first item, “Paper Type,” on the bottom line.
2Press Enter to access the menu item.
3Use the scroll button (W or X) to find the paper type you are using and press Enter to save it.
4Press the X button to scroll to “Paper Size” and press Enter to access the menu item.
NOTE: If you are using envelopes or card stocks, you don’t need to set the paper size.
5Use the scroll button (W or X) to display “Manual Feed” on the bottom line. Press Enter to access the menu item.
6Use the scroll button (W or X) to find the paper size you are using and press Enter to save it.
7To return to Standby mode, press Stop/Clear.
Making a Copy
1Load the documents up to 20 pages face down into the ADF and adjust the document guides to the document size.
See page 2.2 for further details about preparing a document and loading it into the ADF.
2Customize the copy settings including number of copies, copy size, darkness and original type by using the control panel buttons. See the following section. Sorts the copy job. For example, if you make 2 copies of 3 page documents, one complete 3 page document will print followed by the second complete document. see page 2.14
BASIC FUNCTIONS 2.11