
Function | Selections or |
Prompt | Range of Setting |
Lower Display | Upper Display |
LOW VAL | Low Scale Value |
| within the range of |
| the selected |
| variable to |
| represent the |
| minimun output (0 |
| or 4 mA) |
|
|
HIGH VAL | High Scale Value |
| within the range of |
| the selected |
| variable to |
| represent the |
| maximum output |
| (20 mA) |
|
|
DIG INP1 |
|
| NONE |
| TO MAN |
| TO LSP |
TO 2SP
TO 3SP
TO DIR
TO HOLD
TO PID2
PV 2IN
RERUN
Parameter
Definition
AUXILIARY OUTPUT LOW SCALING FACTOR— This is a value in engineering units used to represent all AUX OUT parameters except Output.
For Output, this is a value in percent and can be any value between
AUXILIARY OUTPUT HIGH SCALING FACTOR— This is a value in engineering units used to represent all AUX OUT parameters except Output.
For Output, this is a value in percent and can be any value between
DIGITAL INPUT 1
NO DIGITAL INPUT SELECTIONS
TO
TO LOCAL
TO LOCAL SETPOINT
TO LOCAL SETPOINT
TO DIRECT
TO
| Run |
|
was not previously started via the | Hold | key. |
|
This selection applies to either loop.
TO
PV=INPUT
54 | UDC3200 Universal Digital Controller Operator Manual | 04/08 |