Sanyo srt-6000 Setting the Cassette Eject Mode, Cassette Eject Setup, Eject terminal connection

SETTING THE CASSETTE EJECT MODE

Cassette Eject Setup

When using 2 VCRs or more, the cassette tape of all the VCRs or some of the VCRs can be ejected, if the EJECT terminals on the VCRs are connected as indicated.

1Press the MENU button until the (SET UP 4) menu is displayed.

@@@@@@@<SET@UP@4>

öSW@OUT

@@FIELD@@@@@@@@@01

@@TIMING@@@@@@@@FIELD

@@8H@@@@@@@@@@@@Y

öTHREAD@CHECK@@@Y

öVIDEO@LOSS@@@@@N

öREC@SPEED@@@@@@N

öEJECT@SET

@@EJECT@MODE@@@@EJECT1

@@OPERATION@@@@@SLAVE

2Turn the JOG dial, until the “EJECT MODE” setting is flashing.

3Turn the SHUTTLE ring to set the desired cassette eject mode.

EJECT1 . . . . The cassette is ejected only if the VCR is not in recording mode.

EJECT2 . . . . The cassette is ejected only if the VCR is in stop mode.

4Turn the JOG dial clockwise, until the “OPERATION” setting is flashing.

5Turn the SHUTTLE ring to set the desired operation.

SLAVE . . . . . When the EJECT button is pressed, the cassette tape of that VCR only will be ejected.

MASTER . . . When the EJECT button is pressed, the cassette tape of that VCR and of any VCR connected after it will be ejected.

6Press the SEARCH button to save the settings.

øThe setting procedure is now completed.

EJECT terminal connection

VCR No. 1		VCR No. 2
	EJECT		EJECT
COM OUT IN		COM OUT IN

EJECT IN terminal

œDepending on the (SET UP 4) menu “EJECT MODE” setting (see “Cassette Eject Setup”), the cassette loaded in the VCR is ejected when there is an input at this terminal.

EJECT OUT terminal

œWhen the EJECT button is pressed (if the VCR is setup as “MASTER”, see step 5 under “Cassette Eject Setup”) or when there is an input (trigger) at the EJECT IN terminal, a signal is output at this terminal, even if the security lock is set or if a cassette is not loaded.

NOTE:

œThe EJECT button will not be operative during recording mode.

32 English