Klark Teknik DN9340E specifications DN9344E Front Panel

Quick Reference

1.2. DN9344E Front Panel

1 2 1 5 7 1 2 1 5

3 4 6 8 9 3 4 6 10

1Remote control active These show that that the master unit is currently controlling indicators (green) x 4 the channel by remote control. Often referred to as the

“me” light. There is one indicator for each of the channels 1A, 1B, 2A and 2B.

2Alphanumeric displays Each section has two large, red, three-digit alphanumeric

for sections 1 and 2 displays that show electronic scribble-strip information, Last Memory Recalled and Communications Mode, or Set Up menu options.

3Display mode indicators (blue) for sections 1 and 2

Each section has a blue indicator that illuminates to show that the large, red alphanumeric displays are showing Last Memory Recalled and Communications Mode. When extinguished, the displays are showing electronic scribble-strip names.

4	Scribble Strips for	Scribble-strip areas allow easy labelling of the unit. Use
	sections 1 and 2	only chinagraph pencils to avoid permanently marking the
		unit. Remove chinagraph markings by wiping with a soft
		cloth. Do not use solvents as these may damage the
		surface.

5UP and DOWN buttons for sections 1 and 2

6Metering

7SETUP button

8PC port

9Communictions traffic indicators

10Power panel

Used to select various set up menu options including the communications channel for remote control and also contact closure mode. Active only when in the SETUP menu.

Input, and Output metering incorporating multi-point clip indication.

Press and hold for one second to access Set Up menu, then press to step through the Set Up pages.

Use with the supplied cable to install software updates or to control the unit from an external computer.

These indicate when there is communications activity on any of the external interfaces. Transmit and receive data LEDs are shown for NETWORK (rear panel Ethernet data), DATA (front panel RS-232 PC port data) and RELAY (the rear panel RELAY contact closure input). In addition, IP ADDR and SUBNET LEDs illuminate when the IP Address or Subnet mask setup menus are selected.

Power switch and power ON indication.

4