Setup Menu: DN9340E
7.4. Analogue/Digital Input Select (Page 3)
This page selects the input source for input channels A and B on a paired basis due to the sharing of channels for the AES/EBU input. There are six options available:
•‘Anlg INT’
•‘Anlg WCK’ - audio source is analogue inputs. Internal digital clock is synchronised to external word clock input (either 44.1 kHz or 48 kHz).
•‘Dig INT’ - audio source is digital input via sample rate converter (input source sampling frequency up to 96 kHz). Internal clock is synchronised to
•‘Dig WCK’ - audio source is digital input via sample rate converter (input source sampling frequency up to 96 kHz). Internal digital clock is synchronised to external word clock input (either 44.1 kHz or 48 kHz).
•‘DLck AB’ - audio source is digital input bypassing sample rate converter (input source either 44.1 kHz or 48 kHz) to eliminate converter latency. Input digital clock is synchronised to clock derived from digital audio input. Note: clock reference setting must match frequency of digital audio input.
•‘DLck WCK’ - audio source is digital input bypassing sample rate converter (input source either 44.1 kHz or 48 kHz) to eliminate converter latency. Internal digital clock is synchronised to external word clock input (either 44.1 kHz or 48 kHz). Note: digital audio input and word clock reference must be the same sampling frequency.
To change the input source
1Step through the Set Up menu to the Input Source select page.
2Use the left control knob to select the input source for channels A and B.
Note |
| The ‘Ref’ menu shows the clock reference for the DN9340E, for example, Internal. |
|
| If the input is set to ‘DigLock’, then this menu becomes active; turn the right control |
|
| knob to select the input clock reference from internal to AB (lock to the channel’s |
|
| incoming AES/EBU bit stream). |
|
|
|
For each of the six input sources the “Ref” and “WLCK” menus each have two options, 48kHz and 44.1kHz.
30