Klark Teknik DN9340E, DN9344E Password, Analogue/Digital Input Select Pages 3, To set a password

Operation: DN9344E

15.3. Password Page (Page 2)

This allows the presets to be password protected to prevent unauthorised editing. The password is six characters long.

To set a password

1Press and hold the SETUP button to open the Comms menu. Press SET UP again.

2Press UP on the right-hand section of the unit (Section 2) to highlight the furthest left digit in that section; a dot will appear at the base of the digit to show that is selected. Set the desired character by using the UP and DOWN buttons in the right-hand section.

3Using the UP and DOWN buttons in the left-hand section to move to the next/previous character, set the other five remaining characters to complete the password.

4When you are satisfied with your password (please make sure you don’t forget it), press SETUP. You can then store the password (“OK SET”) by pressing the UP button in the left-hand section. Or, you can exit without saving (“QUIT”) by pressing the UP button in the right-hand section.

15.4. Analogue/Digital Input Select (Pages 3 and 4)

The next two pages set the input source and clock reference for input channels 1A and 1B, and 2A and 2B on a paired basis due to the sharing of channels for AES/EBU inputs. Each input pair may be switched between analogue and digital, and the clock reference may be set to a number of options. Note that the default options are analogue input, with the clock reference set to internal and a sampling rate of 48kHz.

To change the settings for Inputs 1A and 1B

1Step through the Set Up menus to the Input 1 page (“I1”) shown below:

2Use the UP and DOWN buttons on the left-hand half of the unit (Section 1) to navigate between each of the four display fields. For example, to change the input from analogue to digital, move across to the “ALG” field.

3Now use the UP and DOWN buttons on the right-hand half of the unit (Section 2) to change to a new option, for example select “DIG”.

4Press SETUP to confirm (unit will display password menu).

5Press SETUP to exit.

Note		The available options for each field may be affected by the set-up of
		other fields.
	52