Klark Teknik DN9344E Digital Output Clock Select Pages 5, To change the settings for Output

Operation: DN9344E

15.5. Digital Output Clock Select (Pages 5 and 6)

The next two pages select the clock reference for the digital AES/EBU outputs 1 and 2. Note that the output clock reference settings are independent of sampling frequency. The available options are:

•‘INT’ – the digital output is locked to the DN9344E’s internal system clock. Note that this is the default setting.

•‘WCK’ – the digital output is locked to the word clock reference input located on the rear panel of the unit.

•‘I1D’ or ‘I2D’ – the digital output is locked to the digital input channel’s incoming AES/EBU bit stream from either input 1 or input 2.

Note	The available options for may be affected by the set-up of the input
	source and clock selects, see Appendix A for details.

To change the settings for Output 1

1Step through the Set Up menus to the Output 1 page (“O1”) shown below:

2Use the UP and DOWN buttons on the left-hand half of the unit (Section 1) to navigate between each of the four display fields.

3Now use the UP and DOWN buttons on the right-hand half of the unit (Section 2) to change to a new option.

4Press SETUP to confirm (unit will display password menu).

5Press SETUP to exit.

Note	The available options for each field may be affected by the set-up of
	other fields.

53