TechniSat DigiCorder S2 Mains power connection, External unit, Connection to a television set

4.1 Mains power connection

The digital receiver should only be connected to the mains pwoer supply when all the cable connections with other com- ponents of the system have been made. This helps to avoid damage to the digital receiver as well as to other compo- nents.

aWhen you have made all the other connections, use the mains cable supplied to connect the receiver to a mains power outlet 230 V/50-60 Hz.

4.2 External unit

4.2.1 Operation with 2 antenna signals

To utilise the full range of functions of your digital receiver, you should preferably operate it with two separate antenna signals.

b, c Use suitable co-axial cables to connect the LNB inputs 1 and 2 of the digital receiver with your external unit.

Please also note Point 6.4 (antenna settings).

4.2.2 Operation with 1 antenna signal

In exceptional cases you can also operate your receiver with only a single antenna signal. In this case, however, both the recording function and the PIP function will only be available in restricted form.

bUse a suitable co-axial cable to connect the LNB input 1 of the digital receiver with your external unit.

4.2.3 Operation with a rotating antenna

bWhen using a rotating antenna, connect the DiSEqC motor (Level 1.2) with the LNB input 1.

4.3 Connection to a television set

When you have connected your digital receiver with your television set, it may be necessary to adjust the signal type or the mode of the Scart socket to your television set.

13