TechniSat DigiCorder S2 manual Manual programming of timer, Manage timer, Date, Start, Stop

(Fig. 8-4)

(Fig. 8-5)

8.1.2.1 Manual programming of timer

>Use the Menu key to call up the Main menu.

>Use the arrow keys up/down to mark the line

Manage timer.

>Confirm by pressing OK.

The sub-menu Manage timer will be displayed. (Fig. 8-4)

>Use the arrow keys up/down to select the type of timer you wish to programme.

>Press the OK key to go to the entry window used for programming a new timer event. (Fig. 8-5)

To programme a timer, proceed as follows:

>Use the arrow keys to mark the upper line of the menu.

>Press the OK key.

>In the selection window that is now displayed, use the arrow keys up/down to select the desired source (TV or Radio).

>Confirm by pressing OK.

Now, depending on the previous setting, the TV resp. the radio programme list will be displayed.

>Now use the arrow keys to mark the desired pro- gramme.

>Use the arrow keys up/down to move around the list one line at a time.

>Use the arrow keys left/right to move backward or forward in the list one page at a time.

>Press the OK key to accept this into the timer.

Date

>Use the arrow keys to mark the column Date.

>Use the numeric keys to enter the date (4-digit for- mat) of the timer event.

Start

>Use the arrow keys to mark the column Start.

>In this line, use the numeric keys to enter the star- ting time for the timer.

Stop

>Repeat the steps as described under „Start” to enter the stopping time (except for channel-switching timer).

48