TechniSat DigiCorder S2 manual Automatic scan, Satellite scan, Search mode

(Fig. 9-16)

(Fig. 9-17)

>Now use the arrow keys up/down to select the type of scan you wish to perform, and confirm by pres- sing OK.

9.4.1 Automatic scan

If this scan is selected, all the satellites listed in the menu Antenna settings (Point 6.4 and 10.4) will be scanned auto- matically for programmes. You can decide whether you wish to scan for all programmes (free-to-air and encrypted) or only for free-to-air programmes. (Fig. 9-16)

>Press the OK key to decide whether you wish to scan only for free-to-air programmes (Free Channels) or whether you wish to include encrypted programmes (All channels).

>Confirm by pressing the green function key Start scan.

Depending on the configuration of your antenna instal- lation, a scan can take 15 minutes or more. Please note any messages displayed on screen.

9.4.2 Satellite scan

To scan a single satellite for programmes, select the Satellite scan option (Fig. 9-17).Here you can decide whet- her you wish to scan for all (free-to-air and encrypted) pro- grammes or only for free-to-air programmes.

>Press the OK key again to open the selection table for the active satellites selected in accordance with Points 6.4 and 10.4..

>Use the arrow keys up/down to mark the menu item All satellites, to scan all active satellites for programmes, or mark the desired satellite to scan only this satellite for programmes.

>Confirm by pressing OK.

>Use the arrow keys up/down to mark the field

Search mode.

>Decide by pressing the OK key whether you wish to search only for free-to-air programmes (Free Programmes) or whether you want to include encrypted programmes in the search (All Programmes).

>Now use the arrow keys up/down to mark the field Start search and press OK to confirm. The scan will be started. Please note any additional messages displayed on screen.

>You can abort the search by pressing the red function key.

82